Sunday, April 3, 2011

How To Flush Your Engine-best auto zone


If you're thinking of switching over to synthetic oil here are a few tips to get started.
1.) Flush out the engine with a high quality engine flush. Start by removing the old oil filter and installing an inexpensive filter while you flush the engine. No sense buying an expensive filter for this 20 minute flush job. Check the oil level and make sure you have a full crankcase, don't worry about the extra fluid from the engine flush, it will dilute down and besides it will only be in there for 30 minutes. Next, add the engine flush to your crankcase and allow the car to run for 20-30 minutes. This initial flush will help loosen up the light varnish and start taking debris to the oil filter. After running for 20-30 minutes turn off the car and remove oil filter and drain the oil.
2.) Now install your new synthetic oil along with your high quality oil filter and you're done. Keep in mind if you are using one of the top selling brands of synthetic oil there will be additional cleaning of your engine even after you have flushed it. In older cars you might see some slight oil consumption while the engine is still going through the cleaning process. If you're using one of the extended drain synthetic oils it's always a good idea to check your oil level at least monthly or every 500-600 miles.

If you're using one of the better brands of synthetics you should begin to see your fuel mileage creep up. How would you like to see fuel mileage gains of 3-8%? Wouldn't that be nice with the way gas prices going up all the time. Also, synthetics not only provide better protection for your engine, but also in most cases can allow you to go much longer between oil changes. There are some oils that go as long as 25,000-miles or 1-year whichever comes first.
Remember you can't get cheap and high quality in the same product. Some people may bulk at the initial price of synthetics, but remember it's not the price that matters, it's the cost and there is a big difference. The price of a product tells you nothing of its value, however the cost does. If the synthetic oil you are thinking about buying cost $9.00/quart, but you can go 25,000-miles then how much is that oil really costing you? In most cases you could pay up to $60.00-$65.00 for a simple oil change, but then again it will be the only oil change you pay for the entire year. Most quick lubes charge well over $30.00 for oil change.00-$35.00 for an oil change then turn around and tell you to come back in 3,000-miles. This is in comparison to spending well over $125.00 on 3 or 4 visits to your friendly quick lube dealer. Now do you see the difference between price and cost? Don't be concerned about the higher initial cost of synthetic oil, in the long run you are putting money in the bank.

Article Source: http://EzineArticles.com/6113995

No comments:

Post a Comment